Overview： Silicon carbide is smelted in high temperature with quartz sand, petroleum coke (or char), sawdust. After the silicon carbide become grain go into belt dryer,the material surface will have surface free water, this time in front of the dryer blow it with hot air, then most of the free water removed. At the same time the material begins to warm up, because this time air humidity is high, so the mixing temperature in front units are lower.

Overview：DWF air stream spray belt dryer is special dryer is suitable for drying the material with poor ventilation, the typical example: pulp drying, drying the coating cloth, plate drying. Due to its special nature, in the design according to the nature of the material, the temperature of the hot air, the amount of circulating gas, humidity, air speed and gas stream is not common to most materials, a large practical difference. Therefore, the user when ordering, should discuss with our engineer to make a detailed technical, in order to make rational design to promote better benefits for the user to generate a better performance of our equipment.